Hi guys.Recently i bought standalone Maxxecu Race which i want to install on my car.The problem for me ,is that i do not understand how to wire idle air control valve.I want to use original one(factory installed) from Bosch with part number 0280140553,which is 3 wire motor. I found that middle pin is going to plus 12v,and two other pins are going to factory ECU(in original wiring).Where should i connect them into Maxxecu?Is this type of valve supported?What i found on internet is one of the pins is for closing and one for opening the valve,is this true?
Regards
Idle air control valve
Moderator: backeliten
-
- För mycket laddtryck
- Inlägg: 428
- Blev medlem: tor maj 08, 2014 7:54 pm
- Ort: Växjö
Re: Idle air control valve
I hope you understand Swedish but i found this http://server.pure-pf.com/phpBB/viewtop ... =1&t=90397
Oskar Johansson
Tack till:
http://www.l-m-r.se/
http://www.mkmotorsport.se/
http://forum.savarturbo.se/viewtopic.ph ... 5&start=90
Tack till:
http://www.l-m-r.se/
http://www.mkmotorsport.se/
http://forum.savarturbo.se/viewtopic.ph ... 5&start=90
Re: Idle air control valve
OK thanks,thats what i needed.