Sävar Turbo Site

Hi everyone. I have in mind one little project, i'd like to try to put a centrifugal to t6 engine. My goal is about 650hp from flywheel, i had to go with a one set of cams because i own them and these are not cheap. So it will rev to 8000rpm. I had to do almost all the pulleywork myself, thats not a...

Hi everyone. So, i have a 3.0 liter new long block, ford duratec 3.0. v6 Then i bought pair of ford st200 cylinder heads, they look very good at intake channel. Now i'm thinking that it has 2 32mm intake valves, how much it can produce power with those valves as a restriction? I also think that i'm ...

Hi, i have a project to combine a b4164s block with a crankshaft of a b4204t engine. I will spice it up a little, bigger turbo (not going to huge size somewhat obvious reasons), i think about maxpeedings 3/4, compressor inducer 52.7mm, exducer 76mm, turbine will be a bottleneck at this combination, ...

I will say that ultra high static cr results in theory somewhat smaller cylinders when compared to same engine with heads with bigger combustion chambers. Incoming air-fuel mix have a mass, actually is quite large, but anyway it can fill cylinders with over 100VE% and if that occurs, so we will get ...

Jag har en Volvo b4164s /b4204t/b4204s hybridmotor som ett projekt. Vad tror ni, hur mycket flöde kan ett lättportat lock med standard ventilstorlek, med lättportning menar jag den så kallade grundläggande fickportningen och ventilarbete, storleken på själva kanalerna kommer inte att ökas, utan vägg...