Sävar Turbo Site

Hi guys.Recently i bought standalone Maxxecu Race which i want to install on my car.The problem for me ,is that i do not understand how to wire idle air control valve.I want to use original one(factory installed) from Bosch with part number 0280140553,which is 3 wire motor. I found that middle pin is going to plus 12v,and two other pins are going to factory ECU(in original wiring).Where should i connect them into Maxxecu?Is this type of valve supported?What i found on internet is one of the pins is for closing and one for opening the valve,is this true?

Regards

I hope you understand Swedish but i found this http://server.pure-pf.com/phpBB/viewtop ... =1&t=90397

OK thanks,thats what i needed.