Hej alla .
Jag har precis kommit över en 240 som jag är lite nyfiken på att uppgradera motorvalet av. Vill gärna hålla mig till 4 cylindriga motorer.
Lite frågor:
T4 motorn, passar de motorfästen man använder till 5a / 6a ?
Växellåda m90h?
Antar att 4 cylindern är samma som 5 cylindern ? En kortad variant av den gamla 6 an ?
M42 motorn , passar den med m50 ASS fästen ? Är det samma block fast kortare ?
Tack på förhand , va många år sedan jag höll på men nu börjar jag få lite sug på ladd
Skickat från min iPhone med Tapatalk
B4194T/m42b18 i 240
-
- Lite mer laddtryck
- Inlägg: 14
- Blev medlem: tis nov 10, 2020 1:54 pm
Re: B4194T/m42b18 i 240
Put a t4 engine with a 81mm bore to it.
With h-profile rods and decent pistons to it, then it can handle a quite a bit of power.
And it is by nature kind of torquey/broad power curve type of engine because of long stroke and 4-valve head.
Original camshafts are very mild so they had to be changed if you need good power.
With decent camshafts and mild port work this engine revs to 9000rpm.
If you put a big turbo to it which spools at 5000rpm, like gtx4202r or something this size you have 4000rpm powerband, and if your max nm is example 750nm, then you can have over 400nm all the way at 5000 to 9000rpm.
With h-profile rods and decent pistons to it, then it can handle a quite a bit of power.
And it is by nature kind of torquey/broad power curve type of engine because of long stroke and 4-valve head.
Original camshafts are very mild so they had to be changed if you need good power.
With decent camshafts and mild port work this engine revs to 9000rpm.
If you put a big turbo to it which spools at 5000rpm, like gtx4202r or something this size you have 4000rpm powerband, and if your max nm is example 750nm, then you can have over 400nm all the way at 5000 to 9000rpm.